It's also loosing all the save path settings set in the categories/labels. Issue: Is that my container looses it's configuration, well most of the configuration such as the set password password (it reverts to the default one). It doesnt happen if i restart the container when my host is running The issue is happening when i'm restarting my Unraid Host. Hi! I've got an issue with using this container. I suspect it's something i've done so will play around for a couple more days and will post the last two things (log and run section) if i can't work it out. The arr services access the qbittorrent webUI via 192.168.1.90.Īny idea why this occurs or how to get the desired behavior? Ideally, I'd like to be able to use 192.168.100.90 and 192.168.1.90 interchangeably and have them resolve to the same place.Ĭhecked Lan IP, incognito (adblock disabled), VLan and pihole turned off. However, the Qbittorrent webUI is only reachable at IP_1 - 192.168.1.90. Both IPs resolve to the correct service (depending on port used). To reiterate, I can access Unraid, Sonarr, Radarr, Heimdall, Plex, etc. Optional IP address to bind to: All addresses Secondary NIC (eth2) - 10gbe direct connect to pc FWIW, I can access those other services using the secondary/private NIC address (IP_2) even though they're all set-up to use the primary ip (IP_1). How do I best configure things so I don't cause any issues with other services (Sonarr, Radarr, Plex, etc.). I'd like to access the qbittorrent WebUI via this private connection. I have a second NIC installed in my Unraid server and it's direct connected to my pc (no DHCP server, not part of the home network). However, since the webui currently is running on the same network as my primary 1gbe home network, it can become quite sluggish when downloads saturate my internet connection (1gb symmetrical). I'm currently running binhex-qbittorrentvpn and it works quite well. Pihole/pfsense/opnsense/router blocking - check firewall, especially if you are running advanced firewalls such as *sense.Īlso can you please left click the icon, select edit, make a change to anything, then change it back to what it was and click 'apply' at the bottom, then copy and paste the subsequent text that appears ( docker run command).Īnd lastly can you please refresh the log by doing this again:. Vlan blocking - if you define vlan's ensure the vlan allows traffic to/from the web ui port Host blocking - check that the device running the browser does not have a firewall blocking the ui port Wrong lan_network - confirmed the device running the browser has an ip of 192.168.1.xxx right?īrowser blocking - are you running adblock?, try incognito to rule out plugin issue, try a different browser Ok please run through the possible causes list below (yes this will be a faq at some point when i get a min!):. I have to disable the VPN to access the Web UI. I set it back to Bridged mode and same thing happens.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |